Overrun and then line up when changing gears.
When changing gears under load going up the Eagle cassetter (smaller to larger/higher to lower gear), the change can be clunky. To get around this on a cable actuated derailleur I sub-conciously push the lever a little further than required to make the change happen more quickly then release the pressure on the lever so the derailleur returns to the correct alignment for the new gear. Please can we have an adjustable "overrun" in AXS to mimic this behaviour ? It would be really swish if this worked going the other way too as the change can be delayed a little going 3rd/4th, 4th/5th and 5th/6th (note 1st is the 50 tooth, 12th is the 10) since this is driven by a spring and not a servo.
-
dklebay@yahoo.com commented
I thought I was the only one that thought it was clunky.