I would be really useful as a service tool if it were possible to make micro adjustments directly from the app in addition to adjusting them from the controllers

Because it does not update to the newest firmware.
RD-RED-E-01 and FD-RED-E-01 still on 2.17, 2.7.3 would be the lastest version.

The app will not function unless connected to the internet (quark tirewiz). Kills the usefulness when in many trails where there is no cell coverage. Stop requiring internet connection.

Microadjust all gears one by one. Rear derallieur.

Bei der Weiterentwicklung sollten alle verfügbare SRAM Komponenten eingebunden und auch getestet sein in der Version stürzt die App beim Aufruf von tirewiz Komponenten einfach ab

Ensure that on bike devices (e.g. Garmin Edge) battery condition is shown in % an not only as a graphic and show it for all batteries (front / rear / shifters) separatly :)

The application should allow you to rollback the firmware to a previous version.

I just installed a version that was confirmed to have an issue with components waking up, and I cannot rollback to a previous version.

Why show trip summery on the web? Put all info in the app! Only using the app for connecting/updating the components is an useless app.

Normal rapid button presses would be limited to 3-11, a long press would get me into the big ring, once in the big ring the upper limit would be disabled until I get below another ring like 5. Currently I have to rapid shift till I get to big ring then drop down one gear. Same with small rings, rapid shifts would stop at 3, long press would get me to 2, once in 2 short presses would shift up or downone gear at a time, if I go past 5 then my lower limit of 3 gets re-enabled

I’d like an option to make Multi Shift stop at 2nd Gear (2nd lowest). My Eagle XX1 52t is good in some scenarios, but almost never necessary. I find when I’m trying to shift down for a short punchy climb I end up in that lowest gear, and then need to shift up one gear. It would be nice if multishift could move me up to 2nd gear but require a short press to pop down into that big 52t.

Maybe its possible to implement a way to flip through the pages of the bike computer by using die clics or blips.

As its possible to configure both ports per side it would be nice to configure it to use a pair of clics or even only one clic to scroll through the pages of e.g. a wahoo elmnt bolt thats paired to the axs system.

The current iOS version crashes when an firmware update is triggered.

Current version will not allow me to pair my AXS components to the app so I can’t make any adjustments. I get unending loading circles when trying to add systems/components in the app. And yes, the Bluetooth on my phone is on. And yes, I shook the bicycle and pressed the buttons on the components.

I use to see the tooth count on the rear cog on the gear usage. Now I just see gears numbered one through twelve. I have edited drivetrain and it remains the same

Be able to program which when up/downshifting the combination of front and rear chainring/cog.
Now the front derailleur shifts to the smaller chanring when the rear chainring is on the second biggest cog and I would like it to go to the smaller chainring before.

migliorare l'app è molto instabile si disconnette sempre e nn si riescono a fare gli aggiornamenti sui dispositivi da migliorare

Les mises à jour vers le nouveau firmware de l’AXS ne fonctionnent plus depuis la dernière version IOS 2.0.2 !!!