Chainring data are incorrect
My data for at least one ride are showing I was in the small ring the whole time when I was definitely in the big ring the whole time.
This issue will be resolved on all Garmin Edge xx30 series cycling computers with Garmin’s impending release of new firmware. The beta firmware is available here:
about Eagle 10-50t...Garmin 1030,
Axs Web doesn't show all 12 rear cogs but only 11 ( only from 12T to 50T)
I have the Same problem
Issue: often the application does not record the time spent with the 10T
Same problem !
Just complete a short train, using only one cog. You will be surprised will the train report. You will see that although you actually used only one certain cog, the train report will show that 2 or 3 cogs were used.
Good idea for an app but needs some work. My ride summary shows that I spent virtually the entire ride, (more than 2 hrs) in the 33T chainring but only 0.06% in the 46T. This is exactly opposite of what it should be. This reversing of chainring usuage appears in all my ride summaries.
Paired with garmin 1030, front chainring 36 rear 10-50 T..... report +1 rear cog.....if I use 14 rear report 16...if I use 16 report 18 etc.etc.
Due problemi: nella bici da strada rileva sempre la corona più piccola; sia su strada che in MTB non rileva mai il pignone 10
I have 12 speed but it is only showing shifting for 11 speed. Does not show any shifts to the 12th ring. This was working until recently.
Similar problem for me. Seems like indexing is incorrect.
Show me in big ring when I’m not and never shows me in small ring which I was...
same for me
Both chainrings labeled correctly now and all cogs displayed. 👍🏻
Correct the mileage on the AXS feed.
1 - Milage is out by 1 decimal place. 30.5km reads 305 km
2 - shows me in 50T for most of ride when did not use 50T at all.
Great app otherwise.
After ride axs web “gear usage” Shows that I only been using 37t the whole ride and zero usage of 50t.
However looking at “power in gear” it shows that 50t was used.
better ratio plz
Stesso problema. Il riepilogo dei rapporti indica che Non è mai stato usato il 10T quando invece l'ho usato molto.
Secondo me è tutto slittato di un pignone in su
So today I did a flat ride a purposely did not use 50T and 42T but did spend some time in 10T. (Eagle)
The app showed me using 42T and not 10T.
It looks like the indexing is out but 1 gear.
Io uso i rapporti 1×34 con il 12 v. 10/50. Durante l'allenamento vengono visualizzati i rapporti corretti, ma nel report finale viene visualizzato, erroneamente che non è mai stato utilizzato il 10T.